touch lamp desk light 3 way sensor switch,touch on off switch

touch control switch, touch lamp desk light 3 way sensor switch,Offering quiet, comfortable, touch-operated technology, Novella S perfectly fits in to all places where even,

How Do You Wire A brand new Light Switch To An Existing Light Switch

Wireless Touch Switch Black 2 GANG 1 WAY Remote Control Light SwitchAnswer touch lamp desk light 3 way sensor switch for USA, Canada and countries running a 60 Hz power supply service. The plain answer is that you just cannot! Actually, proper wiring methods aside, in case you install the new light the way you plan, it will only work when the switch is off, and never properly…

Draw it out on paper… <>>>>> You start over. You do not have all the required wires in the box you describe.

All you could have is two hot wires: an unswitched hot from the breaker panel and a switched hot to the light. You couldn’t even add another light from that switch without additional rewiring.

To add lights, you’ll must go to the sunshine fixture and run a new cable (black and white wires) from touch lamp desk light 3 way sensor switch there to the new light. Otherwise, the brand new light would haven’t any neutral connection.

You may, in theory, add a 3-way switch configuration to the prevailing switched wires you mention, after you add the light as described above. For more information about that, with a wiring diagram, see the Related Link shown below.

Electronic remote wireless switches are available to convert a 2 pole switch to a 3 way. Check with your electrical supplier or contractor. <>>>>> As always, if you are in doubt about what to do, the most effective advice anyone should give you is to call a licensed electrician to advise what work is needed. Before you do any work yourself,
on electrical circuits, equipment or appliances,
always use a test meter to make sure the circuit is, in fact, de-energized. IF You are not ALREADY SURE You possibly can Do this JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS.

Answer for USA, Canada and countries running a 60 Hz power supply service. The plain answer is that you just cannot! Actually, proper wiring methods aside, in the event you install the brand new light the way in which you plan, it will only work when the switch is off, and not properly… <br />>br /> Draw it out on paper… <><><> You start over. You do not have all the mandatory wires in the box you describe. &br />>br /> All you may have is 2 hot wires: an unswitched hot from the breaker panel and a switched hot to the light. You couldn’t even add another light from that switch without additional rewiring. >br />>br /> To add lights, you’d must go to the light fixture and run a new cable (black and white wires) from there to the new light. Otherwise, the brand new light would haven’t any neutral connection. >br />>br /> You would, in theory, add a 3-way switch configuration to the prevailing switched wires you mention, after you add the sunshine as described above. For more information about that, with a wiring diagram, see the >b>Related Link>/b> shown below. >br />>br /> Electronic remote wireless switches are available to transform a 2 pole switch to a 3 way. Check together with your electrical supplier or contractor. <><><> As always, in case you are in doubt about what to do, the best advice anyone should offer you is to call a licensed electrician to advise what work is needed. Before you do any work yourself, &br /> on electrical circuits, equipment or appliances, >br />>b>always use a test meter to make sure the circuit is, actually, de-energized.>/b> >b>IF You are not ALREADY SURE You’ll be able to Do this JOB >br /> SAFELY AND COMPETENTLY >br /> REFER THIS WORK TO QUALIFIED PROFESSIONALS.>/b> >br />

Minor edit Save Cancel
Was this answer useful Yes Somewhat No
Thanks for the feedback!

touch lamp desk light 3 way sensor switch

admin

Leave a Reply

Your email address will not be published.