To turn To turn A Hardwired Light Switch Right into a Remote

Adding a remote to a room’s lighting system is a great way so as to add convenience to your house. It also means that you can rearrange your furniture without worrying about blocking a light switch. A remote receiver can be wired into almost any existing light switch. However, wiring is a precise and delicate job. Follow these steps so as to add a remote receiver to your hardwired light switch.

Wireless Gold 3 Gang Touch Switch Touch Screen Light SwitchThings You will Need
Phillips head screwdriver
Flathead screwdriver
Electrical tape
Wire nuts
Red covered wire
Black covered wire

Flip your circuit breaker so that no power is supplied to the switch you wish to replace. Modern circuit breakers are clearly labeled as to which switch provides power to which room, but a number of the older ones are not labeled. If your circuit breaker shouldn’t be properly labeled, flip the main switch to chop power to your entire house.

Unscrew the light switch panel from the wall. Place the screws safely to the side, since you have to to revive them later.

Pull the light switch panel gently from the wall. Pull the wires out gently and stop when you are feeling resistance. Do not pull too hard otherwise you might disconnect the wires’ other end.

Unscrew the wires from the back of your light switch panel using your flathead screwdriver.

Attach the exposed metal portion of each wire to the identical color wire on the top of your remote receiver; twist the wires together to attach them. Twist one end of your extra black covered wire onto the black wire connection. Twist one end of your extra red covered wire onto the red wire connection.

Cap each connection with a wire nut. Wrap any remaining exposed metal wire in electrical tape.

Screw the opposite end of every extra wire connection to the back of your light switch panel. Slide the remote receiver into the wall through the hole where you pulled out the wires. Slide the excess wire back into the wall as well.

Other People are Reading
The way to Wire Downlights Into a Lighting Circuit
The best way to Wire a Five-Way Light Switch

Screw the light switch panel back into the wall. Restore power through your circuit breaker and test your remote light switch.

Related Searches
References
Home Tips: Learn how to Replace A standard Light Switch
Home Lighting Design: How Can a Remote Control Light Switch Save Money and Increase Convenience
Promoted By Zergnet

admin

Leave a Reply

Your email address will not be published.