To make use of To use A Double Pole Electric Light Switch As A Single

Gold 1 Gang 1 Way Wall Touch Switch Wireless

Double pole light switches, sometimes called a four-way switch, are essentially two single pole switches put together. One switch controls two separate circuits. This is typically used in a series of three switches on one circuit to control a circuit from multiple locations. A double pole switch can be used to control two lights–or a light and a fan–on separate circuits. Wiring a double pole switch to work as a single pole switch is straightforward, as only one side is used rather than both.

Things You will Need
Screwdriver
Wire nut
Grounding nut
Wire stripper
Needle nose pliers
Voltage tester

Shut off the ability to the area you’re engaged on. Make certain to test the switch with the voltage tester to ensure there isn’t any voltage present.

Pull out the wires present in the electrical switch box where you’re going to put your light switch.

Strip the coating from the black wires back just far enough to make a loop to go around the screws on the side of the switch.

Strip the coating from the white wire far enough to twist them together. At this point you should have two black wires, two white wires and two bare wires.

Connect the bottom wires– the bare wires –together by twisting them. Twist one onto the opposite about 6 inches from the tip of one. Thread the one wire through the grounding connector. Screw it on tightly when it reaches the twisted section.

Twist the ends of the two white wires together and screw the wire nut onto the tip. Be sure no bare wire is visible, if there’s, cut the tip of the wire.

Fold the white wires in regards to the height of the electrical box. Push them to the back of the box. Done properly, they should rest in the back of the box easily and taking up little room.

Other Individuals are Reading
Easy methods to Wire a Double-Pole Three-Way Switch
How to install a Leviton Three-Way Light Switch

Attach the single protruding bare (ground) wire to the green screw at the underside of the light switch. You will need to curl the wire slightly with the needle nose pliers, making sure the wire wraps across the screw in a clockwise direction.

Loosen the screws on one side of the light switch. Make certain not to use only top or bottom screws. Use one screw in the “On” position, and one screw on the identical side within the “Off” position.

Attach the black wires to the 2 screws using the same clockwise wrapping technique as the bottom wire. It doesn’t matter which black wire goes on the highest or bottom.

Push all the wires into the box, folding them as they go. This ensures that the switch sits correctly on the box and does not have much pressure coming from the wires.

Attach the light switch to the box with screws and put the cover plate on. Restore power and check that your light switch works.

Tips it will help guard against shorts and arcing.
Never assume the facility is off; check it yourself. If you have no voltage meter, you may have to modify off all the power to the house to make sure.
Related Searches
References
Wire It Yourself: The way to Wire Electrical Switches

Photo Credit switch image by Clark Duffy from Fotolia.com
Promoted By Zergnet

admin

Leave a Reply

Your email address will not be published.