To install To install A Light Switch Timer

The cost of the price of electricity steadily rising, many persons are looking to avoid wasting money on this area. Installing a timer on your light switches is a method you can do this. Timers are available two major varieties. Some will limit how long a light is on, anywhere from a couple of minutes to an hour. These are great in bathrooms and closets. Other timers will automatically turn on and off lights at specific times. These are great if you need to make sure lights are off when you go to work or if you are planning a vacation and wish to make it look like you might be home. These instructions will guide you on how to put in single switch timer. A single switch is a light that’s controlled by only one switch.

Things You will Need
Neon voltage tester Flathead screwdriver Phillip’s screwdriver Wire stripper Wire cutters Needle-nose pliers Light switch timer Wire nuts/connectors Electrical tape

Turn off the power to the switch on the circuit breaker. If there may be any chance someone might try to “fix” the electrical outage while you are working on the switch, place a note on the breaker indicating that you are working on it.

Test that the power is off by utilizing your neon voltage tester to test an outlet near the switch. Do that by inserting the red wire into the new side of the plug, and place the black wire within the neutral side of the plug or on the screw of the plate. If it glows, your power is still on.

Remove the faceplate to the light switch.

Remove the 2 screws that secure the present switch, after which gently pull the switch out of the wall box.

Test the switch together with your voltage tester by placing the black wire on the recent wire (either red or black wire) and the white wire on the neutral wire (white or copper grounding wire). If the neon light glows, you still have electricity connected to the switch. Repeat Step 1 and Step 5 until the sunshine does not glow.

Unscrew the screws holding the wire to the terminal of your old switch and take away it. If there are wires running from the switch to plastic caps (generally known as wire nuts or wire connectors), pull off the caps and untwist the wire to remove the old switch.

Strip or trim the wires on the switch and the wall so that approximately 1/2 to three/4 inch of bare wire is showing.

Other Individuals are Reading
How to put in a Timer Switch
How to put in a Bathroom Fan Timer

Twist one black wire from the new timer switch to 1 black wire from the wall with your needle-nose pliers. Then, cover the wire ends with a wire nut. Make certain it is on tightly, and secure with electrical tape.

Twist the other two black wires together together with your needle-nose pliers, and cover the wire ends with a wire nut and electrical tape. If your switch has one black wire and one blue wire, then connect the second black wire from the wall to the blue wire on the switch. In this case, there’ll even be a red wire that isn’t used. Simply cap the wire with a wire nut.

In case your switch has a green grounding wire, connect that to the ground wire (usually a bare copper wire). If it doesn’t have one, fasten the bottom wire to the metal box or the metal bracket on the timer.

Wireless Touch Switch Black 3 GANG 1 WAY Remote Light Switch

Tuck the wire into the box, and push the timer gently into place. Secure it with the screws provided.

Replace the brand new faceplate with the screws provided.

Turn the facility back on on the circuit breaker and test your new light.

Photo Credit Pheaber
Promoted By Zergnet

admin

Leave a Reply

Your email address will not be published.