To connect To attach A mix Switch And Tamper-Resistant Outlet

If you happen to need both a tamper-resistant outlet and a switch in a single space, you may install a mixture device that can fit each of those in an area that may normally house a single outlet. The basic idea behind these devices is that a single wire carries power to both of the devices, which allows for constant power on the outlet and the power to change attached lights or other devices on or off.

Wireless Gold 2 Gang 1 Way Wall Touch Switch

Things You’ll Need
Wire cutters
Screwdriver
1 foot of 14-2 wire
Switch/tamper-resistant outlet device
Outlet wall plate

Be certain that power is disconnected at the breaker panel before beginning work on any wires.

Identify the wires present within the box. There should be no less than one line carrying power (but possibly more) and a wire that goes to the device to be controlled by the switch.

Examine the back of the switch and tamper-resistant outlet combination device to locate where the wires should attach. Generally, one side should have silver screws, and one side should have gold screws. There should even be a small metal tab between the 2 gold screws.

Isolate the ground wires. Tightly twist and crimp them together. Cut off all of the long ends except one. Twist this around the green screw on the device. Tighten the screw completely.

Strip the black “hot” wire back about 1/2 inch. If you have multiple wires carrying power, you might want to strip back the black wire of the spare 14-2 and twist it to the ability wires under a wire nut so that you have a single power wire to hook up with the device.

Strip the white neutral wires back 1/2 inch. You might want to strip back the white wire from the spare piece of 14-2 and attach it to the opposite neutrals under a wire nut so you might be left with a single neutral wire.

Attach the hot and neutral wires to the tamper-resistant outlet half of the device. Twist the hot wire across the gold screw and the neutral around the silver screw. Tighten both screws completely. You also needs to tighten the second gold screw completely.

Other Persons are Reading
Find out how to Wire 2 Single Pole Light Switches in the identical Gang Box
The best way to Toggle a Switch Wiring for On-Off-On

Strip the black wire resulting in the light 1/2 inch. Twist this across the silver screw on the switch half of the device. Tighten the screw.

Fold the wires into the box behind the device, being careful not to let any bare wires touch one another. Screw the device into the box and canopy it with a regular outlet faceplate.

Tips & Warnings
Be sure that all screws are tightened completely.
Call a qualified electrician if you’re still unsure of what to do.
Related Searches
References
Do-It-Yourself-Help: Wiring Diagrams for Household Switches

Photo Credit Stockbyte/Stockbyte/Getty Images
Promoted By Zergnet

admin

Leave a Reply

Your email address will not be published.