To check To test An ASKO Dishwasher Level Switch

Wireless Touch Switch Gold 2 Gang 1 WAY Glass SwitchesA level switch, which is also referred to as a pressure switch, keeps your Asko dishwasher from overflowing, but when it’s not working your dishwasher may under- or overfill. Yow will discover the extent switch mounted next to the sump assembly. However, before you test your level switch, you should check the float assembly.

Float Assembly

The function of the float is to trigger the extent switch so it turns off the flow of water to the dishwasher when it reaches the specified level. If the float becomes stuck, it can’t move freely and may keep your dishwasher from filling or draining properly. Before you start working, unplug your dishwasher. To locate the float assembly, remove the lower dishrack and look on the underside of the dishwasher’s tub. Test the float by lifting it several times and letting it drop. Remove the float and search for obstructions. Clean any debris you discover and replace the float assembly. If you discover no debris, or if you happen to dishwasher still isn’t working properly after you clean the float assembly, you’ll need to check the extent switch.

Level Switch

To locate the extent switch, remove the kickplate panel found below the dishwasher door. The level switch will probably be on the precise side of the sump assembly. It may have several wires and one small rubber hose connected to it. Label the wires so you’ll be able to reconnect them properly later. To remove the wires, pull firmly on the slip-on connectors. Don’t pull directly on the wires.

Testing

Use a multimeter to check the extent switch for continuity. Set your multimeter to the bottom setting for ohms of resistance and test each of the three possible pairs of terminals by touching one of the probes on the meter to a switch terminal while you touch the other probe to a special terminal. Press down on the switch’s button. Note the reading, then move one of many probes to the other terminal and press the switch’s button again. Repeat with the final pair of terminals. The readings you receive needs to be either zero or infinity if the switch is nice. In case you don’t see a change within the reading, you might have a bad switch.

Other Problems

If the level switch is working properly, or you’re still having problems after replacing it, it’s best to inspect the water inlet valve and the drain valve and solenoid. Dirty filter screens on the water valve can keep your dishwasher from filling up as can an improperly functioning drain valve. Use a multimeter to check these parts.

AP Wagner: Why are the Dishes Still Dirty?
YouTube: DIY Asko Dishwasher Repair Asko Repair Help
Part Select: The best way to Check the Dishwasher Float Assembly

admin

Leave a Reply

Your email address will not be published.