To change To alter A Light Switch At Home

Wireless White 2 Gang 1 Way Light Switch Touch ScreenYou will have insulated, pointed, electricity pliers, a screwdriver, a pointy knife and good quality electric tape. The primary and most important step to take is to turn the electric power off to the world or switch you’ll be changing. Turn the sunshine on, now go to the electric panel and throw the breaker switch to which the lamp is attached. If they don’t seem to be labeled properly, turn them off one after the other checking if the sunshine went off inside. When it goes off, you might have found the suitable breaker switch. If you do not want to do this, throw all the circuit breakers off.

Now using the screwdriver, remove the screws attaching the switch to the electric box within the wall. Pull it out and take a superb have a look at all the wires screwed to the sides of the switch. They need to have different colors for correct identification, if they don’t you’ll be able to still do the job, don’t worry. Compare the screws of the new switch to those of the old switch, make sure that they’re located in the identical place and that there is identical variety of screws. They will all be the same color with the exception of the bottom screw which might be green.

Here I’ll take a break from the process and explain a little something which is essential. If you are changing a light switch that is the only one used to turn a lamp on and off, any switch will do. When the lamp will be turned on from two or more switches located in different areas of the room, a special switch is required. If this is the case make sure you tell this to the attendant on the hardware store so he sells you the fitting kind of switch. This is not any big deal; they’re just different and have an additional wire connection.

Okay, back to work, the electricity is off and the switch is off the wall too. Take an excellent look on the wire distribution on the used switch identifying every wire and where it is connected. Loosen the first screw on the used switch, using the pliers take it off the holding screw. Using the pliers straighten the wire out and with the night scrape the tip of it so it is shiny and clean again. Make a u shape on the tip and put it around the same screw on the brand new light switch. Ensure the u is tight against the screw base; tighten the screw until the wire is firmly in place. Do the same for all the other screws. Now take the electric tape and wrap the sides of the switch with a few turns covering the screws and the wires. This is a precaution in case that for some reason the screws touch the metal electric box in the wall.

Screw the switch tightly in place and put the cover on. Turn on the circuit breakers within the electric panel and test your new light switch. You could have now become an electrician; you are actually able to alter any light switch in your house, freed from charge on your own time. Congratulations you have got mastered your fear of electrocution by switch change.

admin

Leave a Reply

Your email address will not be published.