The right way to Wire A Pull Switch

Wireless 3 gang 1 way Wall Touch SwitchPull switches are commonly integrated into ceiling light fixtures. In this manner, you needn’t have a wall switch connected to the light in order to turn the ceiling light off and on. Wiring of a pull switch is accomplished by wiring the sunshine fixture itself, which is a straight-forward job that only requires basic tools and just a little little bit of time.

Things You may Need
Wire cutters
Ceiling light fixture with a pull switch
Wire nuts
Screwdriver

Turn off the facility going to the wire you’ll be connecting to the pull switch at your property’s circuit breaker box.

Remove 1 inch of insulation at the end of the wire that will likely be connected to the pull switch together with your wire strippers. Separate the leads so you possibly can handle each one separately. Match the white wire of your wiring to the white wire of the pull switch. Hold the bare ends together and then slide them right into a wire nut. Twist the wire nut to the best to secure the two wires together.

Match the white wire of your wiring to the white wire of the pull switch. Hold the bare ends together after which slide them right into a wire nut. Twist the wire nut to the correct to secure the 2 wires together.

Repeat Step 3 with the black wires of your wiring and your pull switch.

If your house wiring has a ground wire (a bare copper wire) attach it to the metal mounting plate of the pull switch.

Mount the pull switch into the electrical box in your ceiling. Turn the ability back on to the circuit and test operation.

Photo Credit NLGraphics
Promoted By Zergnet

admin

Leave a Reply

Your email address will not be published.