pulse on off switch,touch switch project

touch light switch home depot, pulse on off switch,Touch sensor touch switch module smart car ARDUINO,

How one can Repair A Ceiling Fan Light

Gold 1 Gang 1 Way Wall Touch Switch WirelessThere are always small repairs to do around a house and occasionally they require just a little effort. If your ceiling fan light has gone out and you have determined it isn’t so simple as changing out the light bulb, likelihood is it is the pull switch to the light. You’ll have been dreading getting out the ladder, but as outside temperatures change, you may be wanting your ceiling fan and light to be working properly.

Things You’ll Need
Screwdriver
Ladder
Pull-chain switch
Turn the electricity off to the sunshine at the breaker box. Your breaker box is usually in the garage, but some houses have them within the kitchen or hallway.

Remove the screws that hold the underside of the light fixture in place with a screwdriver. Typically, the fixture has three screws. It will expose the wiring.

Remove the light’s old pull-chain switch from the housing. Remove the 2 wire nuts attached to the old pull-chain switch and install the new switch, securing the sunshine back to the fan.

Tips Bartlesville, Oklahoma
Joe Kelly; pulse on off switch Customer service at Home Depot; Keller, Texas
Photo Credit ceiling fan image by Adrian Hillman from Fotolia.com
Promoted By Zergnet

pulse on off switch

admin

Leave a Reply

Your email address will not be published.